Outboard Motor Repair Outboard Motor Repair  

Outboard Motors

Power Heads

Lower Units

Props

Repair Manuals

Controls, Steering

Trim/Tilt

Power Tilt/Trim

Parts

Outboard Motor Repair


Chrysler
Evinrude
Force
Honda
Johnson
Mariner
Mercury
Minn Kota
Nissan
OMC
Suzuki
Yamaha
2 Cycle Outboard Motors
2 Stroke Outboards
4 Cycle Outboards
4 Stroke Outboards
Aftermarket Outboard Parts
Boat Wont Plane
Bolts
Brackets
Carburetors
Cavitation
Choke
Coils
Compression
Condensors
Controls
Cooling
Cowling
Crankshafts
Cylinders
Diagrams
EFI
Electrical
Engine Cleaner
Engine Smoke
Exhaust
FICHT
Fins
Flywheel
Fouling
Fuel Pumps
Fuel Systems
Fuel Tanks
Gaskets
Gauges
Gear Cases
Generators
I/O
Idle
Ignition
Impellers
Inverters
Kill Switch
Leaks
Lower Units
Lubrication
Manuals
Oil
Oil Injection
Oil Mixture
Old Outboards
Outboard Engine Blocks
Outboard Inboard
Outboard Maintenance
Outboard Motor Prices
Outboard Propellers
Paint
Parts
Pistons
Power Loss
Power Packs
Powerheads
Primer Bulb
RPM
Repair Tools
Reverse
Running Lean
Running Rich
Runs Hot
Sea Drives
Sealants
Shafts
Shifter
Skegs
Spark Plugs
Specs
Spring Maintenance
Starter Motors
Starting Problems
Stators
Steering
Synthetic Oil
Tachometers
Tillers
Tilt Trim
Timing
Trim Tabs
Twin Outboards
V6
Voltmeter
Water Pumps
Winterization
Wiring
Year

Water Pump for 1977 Evinrude 85 Hp

tssauceda I just bought this boat it is a 1977 Evinrude 85hp I dont know how to check for water pump if it is working or not. I did not see any little hole for water to come out of when engine is running. I had it sugmerged in water and started but like I said how do you check if your waterpump is working?

tommy
2002-07-23
oldboat1 My '70 didn't have a tell-tale, and I don't think yours does either. There will be a light spray coming from the two ports on the back of the leg when the t.stat is open, but not necessarily anything very heavy. Hold your hand over the openings and see if you get wet. Without taking anything apart, you can tell if the engine is getting cooling water by touching the tops of the cylinder heads (Watch out for the flywheel.). If you can hold your fingers on the top of the heads for a few seconds, it's getting cooling water. If it's too hot to touch, shut the engine off and assume you need to correct a problem. 2002-07-23
tssauceda Thank you, I will try that this evening I just could not understand at first why no water I was looking for a stream. So are this hole were they look like a cars muffers holes?

Thanks again [Smile]
2002-07-23

If you would like to post your own question for the experts just click on
the Boating Forums tab at the top of the page or click here!

Disclaimer: iboats.com provides this content for the education and benefit of all boating enthusiasts.
We cannot, however, take responsibility for individual postings, nor can we verify the accuracy of any posting.
Please use any information provided from individuals with great care and read any applicable manuals or safety instructions.
Also, if you determine that a posting is inaccurate or offensive in any manner, please use the Contact Us email form found below.

If you would like to post your own question for the experts just click on the Boating Forums tab at the top of the page!


Outboard Motors

Power Heads

Lower Units

Props

Repair Manuals

Controls, Steering

Trim/Tilt

Power Tilt/Trim

Parts

Outboard Repairs | Boats | Outboard Motors | Boat Dealers
Boat Covers | Boat Propellers | Boat Repair | Marine Engines | Outboard Forum Directory
Terms of Use | Privacy Practices | Legal Notices

1-800-869-1686 (Toll Free)
001-801-571-0071 (International Calls)
Copyright © 1999-2009 iboats, inc. All rights reserved.